admin No Comments

The drywall partitioning system from Dana is a system of metal partition composed of ceiling, studs, and tracks. The partitions of Dana Stud & Track are light, unloaded and responsive on site. The measures are cost-effective for any form of commercial, leisure, industrial, and residential development.

By combining, they form a frame that is designed to accommodate single and double-density gypsum wallboards. Dana Stud and Track is available in different widths when fitted with a gypsum board. It has a high wall. Studs can also be joined together from a box when an even more power for the complete drywall partition is needed.

The unit weight of Dana Stud and Track is much less than the conventional unit of comparable thickness to effectively save structural architecture. The section also allows for service inclusion while building. Our partitioning Stud & Track is completely compliant with our furring section ceiling. Studs have a knurled face that helps the wallboard to penetrate with straight screws when connected to drywalls and this allows the builder to finish the drywalls with less effort and time. In domestic and commercial structures from Dana Steel factory, the metal partitioning systems Stud and Track can be used as solid walls.

DRYWALL PARTITIONING - Metal Stud Track

Metal Stud Track

 

Our manufacturing process guarantees the consistency and strength of all Stud and Track parts and accessories. Both tracks have been tested or checked for BS 476 or E-119 fire resistance standards.

Drywall Partitioning – Top and Floor Track fixation

The raw of fixings, with a max center of 600mm must be securely fitted to the ceiling & floor track. If the concrete or screened floor is newly fitted, the installation of the damp proof layer between the surface of the floor and the track portion should be considered. If the wall is wide and it needs to be wider than 3600mm, two studs can be entangled to create a box section.

Stud 2 Board layers max. 50 mm and 4200mm in height

Stud 2 Board layers max. 70mm and 4800mm in height

Similarly, a box of two studs will have a wall height of 7200mm when accessing.

Stud 2 146mm Board layers up to 10500 mm in height.

DRYWALL PARTITIONING

Studs GI Metal Framing Track Partition Supplier UAE

 

It is necessary, when studs are sealed, that only one stud thickness is inside the floor and the ceiling. Studs should be cut to match the floor track and end on the roof track while the other one fits into the roof track and ends on the top of the ground track.

With the wall cavity up to a full diameter of 25 mm, electric lines and pipes can be conveniently accommodated. Additional support may be appropriate for heavy installations such as bathrooms and sanitary fittings.

Doors Openings for Drywall Partitioning

The designers should take into account the thickness tolerance of the form of partitions with respect to the proposed Door Frame Specification. The head consists of a segment of track on either side that is fastened to studs. Where additional supply for heavy door settings is needed, the studs can be sled with the necessary track section of the gauge.

About Us

DANA Steel based in UAE (Division of Dana Groups) is the greatest maker and stockiest of Studs, Track, Furring, Structurals, Fence, Deck, Steel Coils, and Sheets supplies in the whole Middle East covering the U.A.E and GCC area. We supply Chain Link Mesh Fencing to UAE (Dubai, Ajman, Sharjah, Abu Dhabi, Rak, UAQ, and Al Ain), Oman (Salah, Muscat, Ibri, Sohar), Saudi Arabia, Kuwait, Bahrain, and other Middle East areas.

Leave a Reply

Your email address will not be published. Required fields are marked *